Zx50c Drilling and Milling Machine

ZX50C mainly depends on the swivel milling head to perform left-right or up-down operations of rotating about the vertical-axis for machining; consequently, no additional parts are needed to be installed. Supports multiple-angle Processing of Inclined Planes, T-slots and other special-shaped parts compared with ordinary single-modes; It is more versatile in this sense. Also has a hand-wheel for fine adjustment of feed speed; drill hole and thread-tap precisely controlled with low wear; Gear-driven structure is friction loss-transmitting.

A 8-stage adjustable constant-velocity Drive that can transition between idling at 115 revolutions per minute (r/min) and full-load operation at 1,750 r/min depending on the processed part type. At low speeds, it can provide enough torque for heavy-duty operation of materials with high strength; therefore, at this time, the work-piece will not deform under force. A high-speed Option can efficiently process light metals, like aluminium alloys, and also work well on thin-walled parts; it has good surface quality. Belt driven, thus reducing operational noise to enhance workers' work environment.

The machine bed and worktable use high-quality HT200 cast iron that has undergone a dual artificial ageing process to remove internal stresses and thus reduce vibration in the machine. The X, Y, Z three-dimensional guideway are severely supersonic-frequency-quenched (depth 2-4 mm), ground for enhanced wear-resistant strength and stiffness, and precision-spindles of MT4 taper have been installed to achieve smooth spindles with extremely low deviations in roundness. Combined dovetail Table and guide way can bear a relatively large overturning force, precision lead screw in the driving device precisely regulates the moving speed to match the precise positioning requirements of fine-mechanical part and electronic products.

The overall dimensions of the ZX50C are approximately 1100x970x1650mm, and its own-weight is about 550Kg; As such, it is suitable for both small workshops and Studio's relatively constrained spaces. Compared to the large-drill-milling machine and C.N.C. model, it has a very low initial cost, does not require an expensive CNC system maintenance. Simple mechanical design, few failure points to reduce maintenance expenses and service interruptions. Only needs to be lubricated regularly for daily maintenance, cleaned frequently of wear debris in the spindle and guides; Manual Lubricator easily operated so as to prolong its operational hours.